A mixer tap draws from both the cold and hot water supplies, mixing the flow together, before pouring from one spout. The more conventional way is drawing water through different cold and hot pillar taps, keeping the Thermostatic Valve (robinet thermostatique). There are definitely benefits from using a bathroom mixer tap, which we have listed below.
Lots of individuals prefer the sleek and compact appearance of a mixer tap into that of different hot and cold taps. There’s a wide assortment of mixer faucet styles available. They might have sharp, modern lines or be curved with a traditional arch Thermostatic Shower Mixer (mitigeur thermostatique douche). The grips also can vary, from traditional rotating grips to levers which are lifted up and down to control the flow.
Mixer taps may operate equally well on a tub or a bathroom sink or basin. This may be mounted or hand-held to earn a shower bath, and is especially useful where there is not room for another tub and shower enclosure.
With two different taps, you’re restricted to two flows of water–cold and hot. Your control over the temperature of the warm water will be limited to your heating settings although you may, of course, combine the hot and cold water to various degrees in the tub or basin itself. This makes it much easier to just control the temperature of your water, whether you’re running a bath, shaving or washing as it emerges from the faucet.
With different taps, one common way is to run both taps simultaneously, usually using the hot water faucet opened more completely than the cold. It can be tricky to get the mixture right yet and a lot of men and women find they have to stand guard or keep checking back. Running hot and then adding cold water is another frequent tactic but this may cause a possibly scalding bath; particularly dangerous when you have kids. By finding the best temperature using a mixer tap, you can leave the tub to run itself in confidence. Just do not forget about it completely, or you might wind up getting a flood on your hands!
Mixer taps are usually fitted with a flow limiter as this helps prevent too much water being taken in the warm and cold pipes at the same time. In practical terms, you’re most likely to use less hot water when mixing it into one flow, which is great for both your electricity bills and the environment.